 |
| Jim signing off some paperwork |
 |
| Panel startup checklist |
 |
| ELT and GPS install |
 |
| A snapped Alternator bolt |
 |
| Wheel pants are a big job |
 | |
| An Airport visitor |
 |
| interior going in :-) |
 |
| Radio stack installed |
 |
| Rear panels in |
 |
| minimal trim |
 |
| Engine install still needs work |
 |
| A temp window install . our window isstill wrapped |
 |
| Jims butt crack ;-) |
 |
| Getting ready for run ups |
 |
| Jim at the end |
 |
| A sportmans on floats :-) |
 |
| Picture window installed, the silicone takes some time to cure |
 |
| Engine insulation installed |
 |
| Pizzas which where huge , celebrating a successful build :-) |
 |
| This job goes on for a while , they are panels that need a lot of fitting |
 |
| Prop installed! |
 |
| Auto pilot installed ! |
 |
| Alternator installed |
 |
| CHT' and EGT installed |
 |
| Interior going in :-) |
 |
| CSU, Mixture and Throttle rigged, more work to do here |
 |
| All the tail and wings are rigged |
 |
| Autopilot readying to be installed |
 |
| Brian doing the battery install |
 |
| Battery install again |
 |
| Wing tip tangs and counter weights installed |
 |
| The day 10 build |
 |
| The rest of the hangar |
 |
| A troublesome door being fitted |
 |
| The ELT install , having a fiberglass shell you dont need to install the antenna outside |
 |
| The baffles completed |
 |
| The gold strip is the Marker beacon antenna . Another benifit of a fiberglass strip |
 |
| Wheel pants being installed |
 |
| Jimbo |
 |
| End of Day 10 |
 |
| Panel installed !!! |
 |
| The back end all done outside the aircraft |
 |
| Tuned exhaust fitted |
 |
| Jim installing the hinges , Mike about to do his beached whale impression |
 |
| Brian dicussing fitting of the doors |
 |
| Jim installing the CSU |
 |
| Folding the wings |
 |
| A very compact plane once wings are folded |
 |
| Paul is installing and rigging the engine controls |
 |
| Installing vortex generators |
 |
| A new set of floats .... not ours |
